7/32
Finally I had the headlights to do, I cut two small pieces of clear sprue and glued them in place for bulbs then I needed to shape two pieces of clear glazing and score them to make lenses. I used a hole punch to gently knock out two round shapes from clear sheet, these were just the right size to fit over the lamps and proved much better than my experiment to use clear PVA glue dropped into the lamps and although it took on a nice dome shape, when the glue dried it just sank inwards, even after repeated topping up with glue the end result was the same, maybe clear silicon would work for this, being a lot more viscous, something to try next time.
- Created on
- Sunday 9 October 2011
- Posted on
- Sunday 13 September 2015
- Keywords
- 1:24, Frank Dobson, Ouseburn Tpt, Seddon 32:4
- Albums
- Visits
- 799
- Rating score
- no rate
- Rate this photo
0 comments